Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Wichita Falls?
Duct repair and sealing in Wichita Falls typically runs $350 to $1,900 for most homes, with the average job landing around $650 to $1,100. Sealing alone (mastic or aerosol) often comes in at $350 to $750, while repairing crushed or disconnected runs pushes higher because a technician has to open up ceiling or crawl space to get at the damage. We quote every job with a free written estimate before any work starts, so the number you get is the number you pay.
If you’re calling because your electric bill climbed again or a room never gets cool, the duct system usually isn’t working the way the builder promised. Wichita Falls summers sit in the high 90s for weeks and the AC runs hard, so every seam that leaks warm attic air into a supply run costs real money. This guide breaks down what repair and sealing actually costs here in 2026, what moves the price up or down, and when the smarter call is to repair rather than clean around the problem.
- Sealing only: roughly $350 to $750 for a typical single-story home
- Spot repair (one or two runs): about $250 to $600
- Reconnecting a disconnected run: $400 to $900
- Whole-system repair plus sealing: $1,100 to $1,900
- Free written estimate before any work is booked
Call (844) 230-0769 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Duct Repair & Sealing Cost Breakdown (2026)
Here’s what each part of a typical job costs in the Wichita Falls market. These are estimated ranges for common residential work; the written estimate sets the final price.
| Line item | Typical cost | What it covers |
|---|---|---|
| Mastic sealing at accessible joints | $350 – $750 | Sealing visible seams, collars and boot connections in attics and closets you can reach |
| Aerosol sealing of the full duct system | $800 – $1,600 | Pressurized sealant applied from inside the ducts, reaching the runs behind walls |
| Spot repair of a single crushed or torn run | $250 – $600 | Cutting out damaged flex or duct board and reconnecting a clean section |
| Reconnecting a disconnected run | $400 – $900 | Re-hanging and re-sealing a run that has fallen loose from the plenum or trunk |
| Replacement of one flex run | $250 – $500 | New insulated flex duct on a single register, materials and labor |
| Rerouting a collapsed or badly pinched run | $500 – $1,100 | Running a new path through attic or crawl space around the obstruction |
| Whole-system repair and sealing | $1,100 – $1,900 | Fixing multiple runs, sealing joints and boots, testing airflow before and after |
| Pressure and airflow test before and after | Included with repair | Confirms the work actually improved static pressure and register flow |
What pushes the price up? Access is the biggest one. In Wichita Falls, most of the housing stock west of Kemp Boulevard and around the older blocks near Midwestern Parkway sits on pier-and-beam foundations, and a crawl space that’s tight, wet or low makes every repair slower than the same job in an open attic. A single-story ranch with an accessible attic is the easy case. A two-story with a sealed chase and runs buried behind drywall is the hard one. Duct material matters too: old rigid metal duct board with taped joints takes more time to seal than insulated flex, and any system with crushed flex in the attic needs that section cut out and replaced, not taped over.
Temperature also does something specific here. When the attic hits 130 degrees in July, the AC has to work harder to cool the air in the runs before it ever reaches the register, and a leaking supply seam in that attic dumps cooled air into a space that’s already hotter than the outdoors. Sealing those leaks gives back some of the capacity you’re paying for. That’s why we test before and after and show you the number.
What Affects Duct Repair & Sealing Pricing in Wichita Falls
- Foundation and crawl space access. Much of the older housing around downtown Wichita Falls and the streets near the Wichita River sits on pier-and-beam, and a crawl space that’s low, damp, or blocked by plumbing takes longer to work in than a clean attic. That labor shows up in the estimate.
- Attic heat. Summer attic temperatures here regularly push past 130 degrees, which means more time for setup and safety, and less time on the actual sealing before the technician has to cool down. It’s a real cost driver, not a scare tactic.
- Number of damaged runs. One broken run is a small job. Six runs that let go or got crushed during a previous remodel is a whole-system repair, and the price scales accordingly.
- Type of duct material. Insulated flex is common here and generally easier to repair than rigid duct board with taped joints, which takes more time to seal properly and can’t simply be re-taped when the tape has failed.
- Sealing method. Manual mastic sealing on the accessible joints is the lower-cost option. Aerosol sealing reaches runs behind walls and costs more, but it addresses leaks that hand-sealing can’t.
- Whether a cleaning is needed first. If the ducts are heavy with dust or debris, sealing over that is a mistake. A cleaning before the repair is often the right order, and bundles the visit into one trip.
If you want to understand what happens during a cleaning before a sealing job, the duct cleaning specialists at Forge explain the process step by step. Sealing over a dirty system just locks the debris in.
How to Save on Duct Repair & Sealing
Duct work is one of those trades where the cheapest bid usually turns into the most expensive outcome, so “saving” here means paying for the right scope the first time. A few things we tell homeowners who ask how to keep the number down:
- Get the estimate in writing and compare the scope, not just the price. A $300 bid that only re-tapes joints and a $1,200 bid that replaces crushed runs and seals the boots aren’t the same job. The written estimate from any company should say exactly what’s being repaired and what’s being sealed.
- Fix the cause, not the symptom. If a run came loose because of a pest problem or a hack remodel, reconnecting it without addressing the cause means it happens again. We repair what we find, not just clean around it.
- Combine the repair with a cleaning. One visit covers both, and clean ducts take less time to seal because the technician isn’t fighting debris. That’s a real reduction in labor.
- Ask about a pressure test before and after. It confirms the work actually improved airflow. If a contractor won’t test, that’s a sign they’re sealing by eye.
- Take care of accessible leaks with a specialist, not a generalist. A handyman can tape a joint inside a closet. Whole-system sealing that includes the runs behind walls takes proper equipment – the kind of industrial-grade gear the trade leans on for a reason.
- Call for a free estimate. We don’t charge for the estimate visit or for the written scope. Call (844) 230-0769.
If your ducts are in the middle of a larger renovation, we can also tell you when the right move is to seal before drywall goes back up, because that’s the only time some of the runs behind finished walls are accessible.
Duct Repair vs. Full Replacement: Which Makes Sense?
For most homes in Wichita Falls, repairing the existing ducts is the lower-cost path unless the system is failing across most of its runs at once. A single crushed run, a disconnected boot, or a section of torn flex is a repair. A duct system that’s disintegrating from age, or was installed undersized for the home’s layout, is a different conversation. Repairing a few sections of a worn-out system just spreads the cost of the next failure.
The rule of thumb we use: if the repair estimate climbs past half the cost of a full duct replacement, or if the technician finds more than three or four failing runs, it’s worth pricing both options before signing off. A full-system repair and sealing approach is our usual recommendation in that range, because it delivers the most improvement per dollar without tearing out ducts that still have life in them. If a replacement is clearly the better answer, we say so.
For duct repair work on a home you’re managing as a property manager or landlord, the same logic applies, and we can scope the job around tenant scheduling.
When to Get a Duct Inspection in Wichita Falls
Most duct problems announce themselves before they become emergencies. Watch for a room that stays hot no matter what you set the thermostat to, a dust film that returns within days of cleaning, whistling or roaring at the registers, or a visible pile of debris in the return. In Wichita Falls, the change of season is a good time to look: a system that worked in March often doesn’t feel the same by August when it’s carrying the whole load.
If you’ve had a pest problem, a roof leak that dripped into the attic, or a remodel that pushed a run out of its original path, that’s a reason to inspect even if you haven’t noticed airflow problems yet. A run that got crushed during construction doesn’t usually heal on its own. The sooner it’s caught, the cheaper the fix.
Why Professional Duct Repair Beats DIY
Duct repair that reaches the runs behind walls, above ceilings or under flooring takes equipment most homeowners simply don’t have. We use professional-grade systems from Rotobrush and Nikro, and Abatement Technologies gear for jobs that involve contamination or air-quality concerns. That’s the kind of equipment that lets a technician inspect, test, and repair a duct system rather than guess at what’s happening inside it. We work with air-quality brands including Honeywell and Aprilaire where a whole-system approach is warranted, and we keep our protection standards at Guardsman grade on materials and workmanship.
Our technicians have up to 15 years of experience. That matters when a duct run has to be routed around a structural beam or a plumbing line – the job in the training manual isn’t the one in your attic. You can read more about our full Wichita Falls coverage, or call (844) 230-0769 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Understanding Your Written Estimate
A proper duct repair estimate should list the runs being repaired, the runs being sealed, the sealing method, and a pressure or airflow test before and after. It should also flag anything the technician found but isn’t billing for, so you know what’s been looked at. If the scope is thin or the price range is suspiciously wide, ask questions before you book. The estimate we give is the number you pay.
For most Wichita Falls jobs, the estimate visit takes under an hour. If a second visit is needed to complete the work (for example when access to a crawl space or attic requires a return trip), the written estimate should say so. That way you’re not surprised by anything after the work starts.
Quick checklist before signing any duct repair estimate
- Does it name the specific runs being repaired, not just a lump sum?
- Does it state the sealing method – mastic, aerosol, or both?
- Does it include a pressure or airflow test before and after?
- Does it flag anything found but not included in the price?
- Does it show the final price in writing, not a “starting at” figure?
FAQs – Duct Repair & Sealing Cost
How much does duct sealing cost in Wichita Falls?
Duct sealing in Wichita Falls typically costs $350 to $750 for manual mastic sealing of accessible joints in a single-story home, and $800 to $1,600 for full aerosol sealing that reaches the runs behind walls. The written estimate sets the final number. Call (844) 230-0769 for a free estimate.
Is it cheaper to repair or replace ductwork in Wichita Falls?
Repairing is almost always cheaper for a single damaged or disconnected run, at roughly $250 to $900 depending on access. Replacement only starts to make sense when the estimate for repairs climbs past half the cost of a full replacement, or when more than three or four runs are failing at once. Call (844) 230-0769 and we’ll show you both numbers.
Can you repair a crushed duct in my attic or crawl space?
Yes. A crushed insulated flex run is cut out and replaced, usually for $250 to $500 for a single run. If the crushed section is in a crawl space with limited access, that figure moves toward the upper end of the range. Call (844) 230-0769 for a free estimate; the technician confirms the scope on site.
Does duct repair come with a cleaning?
Not by default, but it’s often the right pairing. Sealing over heavy dust or debris is a mistake, and combining repair with a cleaning usually reduces the total labor because the technician isn’t fighting a dirty system. Cleaning adds to the bill, but the combined visit often beats two separate ones. Call (844) 230-0769 to price it both ways.
How long does duct repair take in Wichita Falls?
Most single-run repairs take two to four hours on site. A whole-system repair plus sealing usually takes a full day, sometimes longer if the crawl space access is tight. You’ll get a time estimate with the written quote. Call (844) 230-0769 for a free estimate.
What does a free estimate include?
We come out, inspect the system, identify the failing runs, and explain the options in plain terms. No charge, no obligation. Call (844) 230-0769. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Ready to stop paying for air that never reaches the room? Call (844) 230-0769 for a free estimate on duct repair and sealing in Wichita Falls. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’ll tell you what’s failing, what it costs to fix, and what happens if you leave it. Straight answers, no pressure, written scope before any work starts.
Pricing reflects the Wichita Falls market as of 2026. Forge Duct Cleaning offers free estimates – call (844) 230-0769.
Written by the team at Forge Duct Cleaning.
What Our Customers Say
"Fair price and thorough work. They ran about an hour and a half past the estimated finish time, so don't schedule anything tight after."
- Marisol Castillo"Did the dryer vent while they were here for a small add on price. The dryer now finishes a load in one cycle instead of two."
- Diego Mendoza"Two guys, about three hours, plastic down at every register, and they wiped the vent covers before putting them back."
- Luis Morales